Power Steering Pump - Removal

REMOVAL

NOTE: Review all Warnings and Cautions. Service Precautions .

CAUTION: Cap all open ends of power steering hoses, power steering pump fittings and steering gear ports when disconnected. This will prevent the entry of foreign material into the components during servicing.

1. Disconnect negative (-) cable from battery and isolate cable.
2. Remove air cleaner housing. Air Cleaner Body - Removal
3. Siphon power steering fluid from fluid reservoir.
4. Remove accessory drive belt from belt tensioner and power steering pump drive pulley. Serpentine Accessory Drive Belt - Removal





NOTE: The pressure hose quick-connect is a one-time use component and must be replaced anytime the pressure hose is disconnected at the power steering pump. It cannot be removed from the pressure hose once installed.

5. Remove the entire power steering pressure hose (2) and quick-connect. Power Steering Hose - Removal





6. Remove supply hose (2) at power steering pump (1).





7. Remove three bolts (1) mounting power steering pump (2) to engine.
8. Remove power steering pump (2).

9. If pulley needs to be removed, Power Steering Pump Pulley - Removal