Intake Manifold - Installation
INTAKE MANIFOLD
1. Remove covering from cylinder head ports.
2. Inspect intake manifold seals (2), if damaged replace as necessary.
3. Clean sealing surfaces with Mopar(R) brakes parts cleaner
4. Position intake manifold in place and install bolts.
5. The rubber collar (2) is used for production only. It is not necessary to reinstall them.
6. Tighten bolts to 8 Nm (70 in lbs.) as shown.
7. Tighten bolts to 13 Nm (106 in lbs.) as shown.
8. Connect purge solenoid vacuum line.
9. Connect fuel line (1).
10. Connect brake booster hose (2).
11. Connect PCV hose (5).
12. Connect MAP sensor electrical sensor.
13. Connect throttle body electrical connectors.
14. Install new harness retainer (2).
15. Install air cleaner housing (1)Air Cleaner Body - Installation.
16. Connect battery cables (1,3).