Procedures

STANDARD PROCEDURE - OIL COOLER LINE QUICK CONNECT FITTING DISASSEMBLY/ASSEMBLY

DISASSEMBLY





1. Remove dust cap by pulling it straight back off of quick connect fitting (1).
2. Place disconnect tool (4) onto oil cooler line with the fingers of the tool facing the quick connect fitting (1).
3. Slide disconnect tool down the line and engage the fingers of the tool into the retaining clip. When properly engaged in the clip, the tool will fit flush against the quick connect fitting.
4. Rotate the disconnect tool 60° to expand the retaining clip.
5. While holding the disconnect tool against the quick connect fitting, pull back on the oil cooler line to remove.

ASSEMBLY





1. Align oil cooler line (3) with quick connect fitting (1) while pushing straight into the fitting.
2. Push in on oil cooler line (3) until a "click" is heard or felt.
3. Slide dust cap (4) down the oil cooler line (3) and snap it over the quick connect fitting (1) until it is fully seated and rotates freely. Dust cap (4) will only snap over quick connect fitting (1) when the cooler line (3) is properly installed.

NOTE: If dust cap will not snap into place, repeat assembly step #2.