Installation

INSTALLATION





1. Place seat assembly in vehicle.
2. Connect electrical connector (2).




3. Start front seat attaching bolts.

NOTE: The front BOLTS must be torqued to the specified torque prior to the rear NUTS being secured.

4. Tighten front seat front bolts to 40 Nm (30 ft. lbs.) torque.
5. Tighten front seat rear nuts to 40 Nm (30 ft. lbs.) torque.

WARNING: Do not connect the battery negative cable. Serious or fatal injury may result if the system test is not performed first. Testing and Inspection

6. Place battery access cover into place and install four bolts.
7. Close deck lid.