Engine Mount Replacement - Right Side

Engine Mount Replacement - Right Side (except L96)

Removal Procedure

Caution: When raising or supporting the engine for any reason, do not use a jack under any sheet metal, or the crankshaft pulley, or damage may occur.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

2. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement Upper Intake Manifold Sight Shield Replacement.

3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

4. Remove the right wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .

5. Remove the battery cable attachment on the frame.

6. If equipped, remove the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement Electronic Suspension Front Position Sensor Replacement.

7. Remove exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Right Side Exhaust Manifold Heat Shield Replacement - Right Side.

8. Remove the starter. Refer to Starter Replacement Service and Repair.




9. Remove the engine mount to frame bolts (1).

10. Position an adjustable jack and a block of wood under the engine oil pan and slightly raise the engine.




11. Working through the wheelhouse opening, remove the engine mount to engine block bolts (1).




12. Remove the engine mount through the rear of the wheelhouse opening.

Installation Procedure




1. Position the engine mount to the engine block.





Caution: Refer to Fastener Caution Fastener Caution.

2. Working through the wheelhouse opening, install the engine mount to engine block bolts (1) and tighten to 50 Nm (37 lb ft).

3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.

4. Remove the adjustable jack and block of wood from the engine oil pan.




5. Clean the threads of the engine mount to engine mount bracket bolts using denatured alcohol or equivalent.

6. Apply threadlocker or equivalent to the threads of the engine mount to engine mount bracket bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers.

7. Install the engine mount to engine mount bracket bolts and tighten to 65 Nm (48 lb ft).

8. Install the starter. Refer to Starter Replacement Service and Repair

9. Install exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Right Side Exhaust Manifold Heat Shield Replacement - Right Side.

10. If equipped, remove the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement Electronic Suspension Front Position Sensor Replacement.

11. Install the battery cable attachment on the frame.

12. Install the right wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .

13. Lower the vehicle.

14. Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement Upper Intake Manifold Sight Shield Replacement.

15. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.