Engine Mount Replacement - Left Side

Engine Mount Replacement - Left Side (except L96)

Removal Procedure

Caution: When raising or supporting the engine for any reason, do not use a jack under any sheet metal, or the crankshaft pulley, or damage may occur.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

2. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement Upper Intake Manifold Sight Shield Replacement.

3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

4. Remove the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .




5. Remove the engine mount to frame bolts (1)

6. Remove exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Left Side Exhaust Manifold Heat Shield Replacement - Left Side.

7. Remove the upper (long) and lower (double joint) I-shaft. Refer to Upper Intermediate Steering Shaft Replacement Upper Intermediate Steering Shaft Replacement.

8. Position an adjustable jack and a block of wood under the engine oil pan and raise the engine slightly.




9. If equipped, remove the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement Electronic Suspension Front Position Sensor Replacement.

10. Working through the wheelhouse opening, remove the engine mount to engine block bolts (1).




11. Remove the engine mount toward the front of the vehicle.

Installation Procedure




1. Position the engine mount to the engine block.





Caution: Refer to Fastener Caution Fastener Caution.

2. Working through the wheelhouse opening, install the engine mount to engine block bolts (1) and tighten to 50 Nm (37 lb ft).

3. If removed, install the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement Electronic Suspension Front Position Sensor Replacement.

4. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.

5. Remove the adjustable jack and block of wood from the engine oil pan.




6. Clean the threads of the engine mount to frame bolts using denatured alcohol or equivalent.

7. Apply threadlocker or equivalent to the threads of the engine mount to engine mount bracket bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers.

8. Install the engine mount to frame bolts and tighten to 65 Nm (48 lb ft).

9. Install the upper (long) and lower (double joint) I-shaft. Refer to Upper Intermediate Steering Shaft Replacement Upper Intermediate Steering Shaft Replacement.

10. Install exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Left Side Exhaust Manifold Heat Shield Replacement - Left Side.

11. Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .

12. Lower the vehicle.

13. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement Upper Intake Manifold Sight Shield Replacement.

14. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.