Canister Purge Solenoid: Service and Repair

Evaporative Emission Canister Purge Solenoid Valve Replacement

Removal Procedure




1. Remove the engine cover. Refer to Engine Cover Replacement (Service and Repair).
2. Disconnect the evaporative emission (EVAP) canister purge solenoid valve tube (1) quick connect fitting from the EVAP purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
3. Reposition the tube out of the way.




4. Disconnect the engine wiring harness electrical connector (5) from the EVAP purge valve solenoid.




5. Remove the EVAP canister purge solenoid valve bolt (1).
6. Remove the EVAP canister purge solenoid valve (2) from the upper intake manifold.
7. Remove the EVAP canister purge solenoid valve O-ring seal (3) from the upper intake manifold, if necessary.

Installation Procedure




1. Lubricate the EVAP canister purge solenoid valve O-ring seal (3) with clean engine oil in order to aid with the installation.
2. Install the EVAP canister purge solenoid valve (2) into the upper intake manifold.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the EVAP canister purge solenoid valve bolt (1) and tighten to 10 Nm (89 lb in).




4. Connect the engine wiring harness electrical connector (5) to the EVAP purge valve solenoid.




5. Position the EVAP canister purge solenoid tube (1), and connect the tube quick connect fitting to the EVAP purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
6. Install the engine cover. Refer to Engine Cover Replacement (Service and Repair).