Canister Purge Solenoid: Service and Repair

Evaporative Emission Canister Purge Solenoid Valve Replacement

Removal Procedure




1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (Service and Repair).
2. Disconnect the engine wiring harness electrical connector (4) from the evaporative emission (EVAP) purge solenoid.




3. Disconnect the EVAP pipe quick connect fitting (1) from the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).




4. Disconnect the EVAP pipe quick connect fitting (2) from the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).
5. Remove the EVAP purge solenoid bracket bolt (3).
6. Remove the EVAP purge solenoid.

Installation Procedure




1. Install the EVAP purge solenoid.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the EVAP purge solenoid bracket bolt (3).

Tighten the bolt to 10 Nm (89 lb in).

3. Connect the EVAP pipe quick connect fitting (2) to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).




4. Connect the EVAP pipe quick connect fitting (1) to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar Quick Connect Fitting Service).




5. Connect the engine wiring harness electrical connector (4) to the EVAP purge solenoid.
6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (Service and Repair).