Stabilizer Link: Service and Repair

Stabilizer Shaft Link Replacement (with Rear Twist Axle)

Removal Procedure

1. Raise the vehicle and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




2. Remove the stabilizer shaft link upper nut (1).
3. Remove the stabilizer shaft link lower nut (3).
4. Remove the stabilizer shaft link (2) from the suspension strut and stabilizer shaft.

Installation Procedure




1. Install the stabilizer link (2) to the suspension strut and stabilizer shaft.

Notice: Refer to Fastener Notice (Fastener Notice).

2. Install the stabilizer shaft link nuts.

Tighten the nut to 45 N.m (33 lb ft).

3. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair).
4. Lower the vehicle.