Sunshade Replacement

Sunshade Replacement

Removal Procedure





1. Remove the screws from the sunshade mounting plate.
2. Pull downwards in order to disengage the sunshade from the roof.
3. Pull down the sunshade in order to access the electrical connectors, if equipped with a vanity mirror.
4. Disconnect the electrical connections from the sunshade, if equipped with a vanity mirror.

Important: Do not rotate the sunshade on shaft. Doing so may cause the sunshade to become mis-aligned and not properly retained.


5. Remove the sunshade from the roof.



Installation Procedure






Important: If a new sunshade is being installed, align the sunshade in the same position as the old sunshade. If the sunshade is aligned incorrectly, the sunshade will not be properly retained.


1. Install the sunshade to the roof.
2. Connect the electrical connectors to the sunshade, if equipped with a vanity mirror.
3. Push upwards in order to engage the sunshade to the roof.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the screw to the sunshade mounting plate.

Tighten the screw to 2 N.m (18 lb in).