Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle

Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle

Tools Required
* J 41352 Steering Column Holding Fixture
* J 23653-SIR Lock Plate Compressor




1. Install the upper bearing spring (3).
2. Lubricate the turn signal cancel cam assembly (2).
3. Install the turn signal cancel cam assembly (2).
4. Install the steering shaft spacer (1).




5. Compress the turn signal cancel cam assembly using J 23653-SIR .
6. Install the new bearing retainer (1) into the groove on the steering shaft assembly.
7. Remove J 23653-SIR .





Notice: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in malfunction of the inflatable restraint steering wheel module coil.

8. Install the small wire harness straps.
9. Install the wire harness assembly strap (1).
10. Remove the steering column and J 41352 from the vise.
11. Install the steering column. Refer to Steering Column Replacement Steering Column Replacement.
12. Install the steering wheel. Refer to Steering Wheel Replacement Steering Wheel Replacement.