Exhaust Gas Recirculation Valve Replacement

Exhaust Gas Recirculation Valve Replacement

Removal Procedure

1. Disconnect the electrical connector from the exhaust gas recirculation (EGR) valve.




2. Remove the two EGR valve retaining nuts (1).
3. Remove the EGR valve (2).
4. Remove the gasket (3) from the EGR valve adapter bracket.
5. Clean the EGR valve adaptor bracket from dirt and debris.

Installation Procedure

1. Install a new gasket (3) on the EGR adapter bracket.





Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the EGR (2) valve and 2 nuts (1).

Tighten the nuts to 22 Nm (16 lb ft).

3. Connect the EGR valve electrical connector.