Positive: Service and Repair

Battery Cable Replacement (Positive Cable)

Removal Procedure

When replacing battery cables, use a replacement cable that is the same type, diameter, and length. Additional feed wires may be attached to the positive cables. Additional ground leads may be attached to the negative cables. Always route a replacement battery cable the same as the original cable routing.

1. Follow the above precautions when servicing the battery and cables.




2. Remove the battery carrier cover.





Caution: Refer to Battery Disconnect Caution in Cautions and Notices.

3. Remove the negative battery cable.
4. Remove the positive cable from the starter solenoid.
5. Remove the positive cable from the battery.
6. Remove the positive cable clamps and tie downs.
7. Remove the positive cable from the vehicle.

Installation Procedure




1. Connect the negative cable to the engine.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Connect the negative cable to the frame.
Clean the grounding area and coat it with a copper-impregnated ground sealer.

* Tighten the cable to the engine 7.4 L) bolt to 30 Nm (22 lb ft).
* Tighten the cable to the frame rail 7.4 L) nut to 30 Nm (22 lb ft).