Crankshaft Position Timing Ring: Service and Repair

REMOVAL PROCEDURE

^ Tools Required
- J 41371 Reluctor Wheel Remover





1. Disconnect the battery negative cable from the battery. Refer to Battery Cable in Powertrain Management.
2. Remove the crankshaft balancer from the crankshaft, Refer to Crankshaft Balancer Replacement.
3. Remove the water pump from the engine block. Refer to Water Pump Replacement in Cooling System.
4. Remove the engine front cover from the engine block. Refer to Engine Front Cover Removal.
5. Use the J 41371 to remove the reluctor ring from the crankshaft.

INSTALLATION PROCEDURE

IMPORTANT: Replace the crankshaft position sensor whenever the crankshaft position reluctor ring is replacement.





1. Install the crankshaft position reluctor ring on to the crankshaft.
2. Install the engine front cover to the engine block. Refer to Engine Front Cover Removal.
3. Install the water pump to the engine block. Refer to Water Pump Replacement in Cooling System.
4. Install the crankshaft balancer to the crankshaft. Refer to Crankshaft Balancer Replacement.
5. Connect the battery negative cable to the battery. Refer to Battery Cable in Powertrain Management.