Engine Mount Bracket Replacement - Right Side

Engine Mount Bracket Replacement - Right Side (w/RWD)

Removal Procedure

Caution: With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:

* The steering column
* The intermediate shaft(s)
* The steering gear

After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.




1. Remove the tower brace. Refer to Cross Vehicle Brace Replacement (Service and Repair).
2. Secure the steering wheel in place.
3. Remove the lower section of the steering intermediate shaft. Refer to Lower Intermediate Steering Shaft Replacement (Lower Intermediate Steering Shaft Replacement).
4. Remove the left and right lower engine mount nuts.
5. Install a screw jack with a block of wood under the oil pan for support.
6. Support the rear of the front frame with a screw jack.
7. Remove the frame rear (1) and center (2) mounting bolts.
8. Loosen the front frame bolts (3) 12.7 mm (0.5 in) to 25.4 mm (1 in).
9. Lower the rear section of the frame.




10. Remove the engine mount bracket bolts (1).
11. Remove the engine mount and engine mount bracket as an assembly.




12. Place a location mark (1) on the engine mount (2) and the engine mount bracket (3).
13. Remove the upper engine mount retaining nut (4).
14. Separate the engine mount (2) from the engine mount bracket (3).

Installation Procedure




1. Position the engine mount bracket (3) to the engine mount (2).
2. Ensure to align the location mark (1) of the engine mount (2) to the engine mount bracket (3).

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the upper engine mount retaining nut (4) and tighten to 80 Nm (59 lb ft).
4. Position the engine mount bracket (3) to the engine mount (2).




5. Install the engine mount and engine mount bracket as an assembly.
6. Install the engine mount bracket bolts (1) and tighten to 22 Nm (16 lb ft) and tighten (2) Bolt to 60 Nm (44 lb ft)
7. Raise the rear section of the frame.




8. Install but do not tighten the frame rear (1) and center (2) mounting bolts. Tighten the bolts to 191 Nm (141 lb ft).

Note: Ensure to tighten the frame bolts in sequence.

9. Tighten the frame bolts.

1. Tighten the left front frame bolt to 191 Nm (141 lb ft).
2. Tighten the right front frame bolt to 191 Nm (141 lb ft).
3. Tighten the center front frame bolts to 191 Nm (141 lb ft).
4. Tighten the rear front frame bolts to 191 Nm (141 lb ft).

10. Remove the screw jack from the rear of the front frame.
11. Remove the screw jack and block of wood from under the oil pan.
12. Install the left and right lower engine mount nuts and tighten to 80 Nm (59 lb ft).
13. Install the lower section of the steering intermediate shaft. Refer to Lower Intermediate Steering Shaft Replacement (Lower Intermediate Steering Shaft Replacement).
14. Unsecure the steering wheel.
15. Install the tower brace. Refer to Cross Vehicle Brace Replacement (Service and Repair).