Power Seat Drive Cable: Service and Repair

Drive Cable Replacement - Power Seat

Removal Procedure

Caution: Refer toSIR Caution in Cautions and Notices.
1. Disable the SIR. Refer to SIR Disabling and Enabling Zone 7 or to SIR Disabling and Enabling Zone 9 in SIR.
2. Remove the seat bottom and frame assembly. Refer to Seat Cushion Replacement - Front (Seat Cushion Replacement - Front) .
3. If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.




4. Squeeze the collar of the cable in order to release the cable.




5. Pull the cable out of the fitting until the cable end clears the fitting.
6. Remove the cable or cable/sensor assembly.



Installation Procedure





1. Install the cable or cable/sensor assembly by pushing the ends into the fittings until the clip snaps into place.
2. If the cable is equipped with a position sensor, install the sensor retention clip and connect the electrical connector.
3. Install the seat bottom and frame assembly. Refer to Seat Cushion Replacement - Front (Seat Cushion Replacement - Front) .
4. Enable the SIR. Refer to SIR Disabling and Enabling Zone 7 or to SIR Disabling and Enabling Zone 9 in SIR.
5. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration Procedure. Service and Repair