Garnish Molding Replacement - Center Pillar
GARNISH MOLDING REPLACEMENT - CENTER PILLARREMOVAL PROCEDURE
1. Remove the rear carpet retainer.
CAUTION: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.
2. Remove the front carpet retainer.
3. Pull out on the center pillar garnish molding to disengage the retainer clips.
4. Remove the center pillar garnish molding.
INSTALLATION PROCEDURE
1. Align the center pillar garnish molding clips to the holes in the center pillar.
2. Push in on the center pillar garnish molding to engage the retainers.
3. Install the rear carpet retainer.
4. Install the front carpet retainer.