Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Balancer Replacement

Removal Procedure

Tools Required

- J 39411 Flywheel Holder
- J 38416-B Crankshaft Balancer Remover
- J 39344 Crankshaft Balancer Installer

1. Release the tension from the accessory drive belt.
2. Remove the accessory drive belt. Refer to Drive Belt Replacement Service and Repair.
3. Raise the vehicle on the hoist.
4. Remove the right front wheel.
5. Remove the two splash shields from the wheelhouse.






6. Remove the brace between the engine oil pan and the transmission case.
7. Install flywheel holder J 39411.
8. Remove the crankshaft balancer bolt.
9. Support the engine cradle with the tall screw jack.
10. Remove three engine cradle bolts at the right of the cradle.
11. Disconnect the RSS sensor from the right side lower control arm.
12. Lower the engine cradle to obtain clearance for the J 38416-B below the body rail.






13. Install pilot J 39344 into end of crankshaft.
14. Remove the crankshaft balancer using the J 38416-B.

Installation Procedure

1. Position the crankshaft balancer to the crankshaft.






2. Install the crankshaft balancer using the J 39344.
3. Thoroughly clean the crankshaft balancer bolt threads.
4. Apply engine oil to the threads.
5. Install the crankshaft balancer bolt.

Tighten
Tighten the crankshaft balancer bolt to 50 Nm (37 lb ft).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. The balancer bolt must be tightened an additional 120 degrees. Make a mark on the balancer bolt flange in line with the center line of one of the balancer legs.
7. Raise the engine cradle into position.
8. Install three cradle bolts.

Tighten
Tighten the bolts to 100 Nm (74 lb ft).

9. Reconnect the suspension position sensors to the lower control arms.
10. Remove the J 39411.
11. Install the oil pan to transmission brace.

Tighten
Tighten the four bolts to 50 Nm (37 lb ft).

12. Install the wheel hose splash shields.
13. Install the right front wheel.
14. Lower the vehicle.
15. Install the accessory drive belt. Refer to Drive Belt Replacement Service and Repair.