B: BI30 Does Not Display LO With Temp/Time Switch Pressed

1. With Climate Control Driver Information Center (CCDIC) connected, connect terminals A7 and F2 with a fused jumper.

^ If display reads HI, go to step 2.

^ If display reads LO, replace CCDIC if terminal contact is good.

2. With a fused jumper, backprobe Body Computer Module (BCM) terminal 3C9 to ground.

^ If display reads LO, check/repair GRY/RED (1018) wire for an open.

^ If display reads HI, check BCM terminal 3C9 for good terminal contact. If terminal contact is good, replace the Body Computer Module (BCM).