Sunroof Window Replacement - Front

Sunroof Window Replacement - Front

Removal Procedure

1. Open the sunshade.





2. Open the sunroof to the vent position.

Note:
Ensure the position disk does not drop off.

3. Remove the sunroof window rear bolts, two on each side.

Remove the 4 bolts.

4. Open the sunroof to half open position.

Note:
Ensure the position disk does not drop off.

5. Remove the front window bolts, one on each side.

Remove the 2 bolts.

6. Remove the window.

Installation Procedure





1. Insert the window.

Align and insert the window on one side.





Note:
Position disk may not rotate, since it can cause scratches in the rear glass cover.

2. Install the front window.

1. Insert the 2 long position window panes (1) if equipped.

2. Install the 2 screws (3) with washers (2).

3. Close the sunroof until the rear part is in the vent position.

Note:
Position disk may not rotate, since it can cause scratches in the rear window.

4. Install the sunroof window rear bolts.

1. Insert the 4 long position window panes.

2. Install the 4 screws with washers.





5. Close the sunroof.

Inspect the gap 11.0 + or -0.3 mm (0.43in).





Caution:
Refer to Fastener Caution Fastener Caution

6. Tighten the sunroof, rear.

Press the seal lightly down (arrow).

Tighten the 4 bolts to 4 Nm (35 lb in).

7. Open the sunroof to half open position.

8. Tighten the sunroof window front bolts.

Tighten the 2 bolts to 4 Nm (35 lb in).

9. Install the front air deflector covers.

Insert and clip in covers.

10. When replacing the motor. Refer to Sunroof Motor/Actuator Initialization/Teach Process.

11. Verify the operation of the sunroof.

12. Close the sunroof.