Garnish Molding Replacement - Front Door Frame

Garnish Molding Replacement - Front Door Frame

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover


Removal Procedure





1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Service and Repair) .
2. Use the J 38778 in order to remove the push-in retainer (2) at the front lower corner of the garnish molding.
3. Pull the molding (1) straight down from front to rear in order to release the clips.



Installation Procedure





1. Position the garnish molding (1) on the door frame.
2. Install the push-in retainer (2) in order to locate the molding (1).
3. Press the molding (1) into place from the front to the rear.
4. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door (Service and Repair) .