Engine Mount Bracket Replacement
Engine Mount Bracket ReplacementRemoval Procedure
1. Disconnect the battery ground (negative) cable.
2. Remove the throttle body air inlet duct.
3. Remove the engine mount struts.
4. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
5. Remove the three-way catalytic converter pipe from the right (rear) exhaust manifold.
6. Remove the right front wheel and tire.
7. Remove the right engine splash shield.
8. Remove the engine mount bracket-to-oil pan bolts.
9. Lower the vehicle.
10. Raise the engine, using the J 28467-B.
11. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
12. Remove the engine mount upper nuts.
13. Remove the engine mount bracket from the engine mount.
Installation Procedure
1. Install the engine mount bracket to the engine mount.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the engine mount upper nuts.
Tighten the engine mount upper nuts to 47 Nm (35 ft. lbs.).
3. Lower the vehicle.
4. Lower the engine.
5. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
6. Install the engine mount bracket to the oil pan.
7. Install the engine mount bracket-to-oil pan bolts.
Tighten the engine mount bracket bolts to 58 Nm (43 ft. lbs.).
8. Install the right engine splash shield.
9. Install the right front wheel and tire.
10. Connect the three-way catalytic converter pipe to the right (rear) exhaust manifold.
11. Lower the vehicle.
12. Remove the engine support fixture.
13. Install the engine mount struts.
14. Install the throttle body air inlet duct.
15. Connect the battery ground (negative) cable.