Canister Purge Control Valve: Service and Repair

EVAP Purge Valve:

REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Note the position to the [1][2]EVAP hoses for installation.
3. Disconnect the electrical connector and hoses from EVAP canister purge valve.
4. Release the lock tab on the solenoid mounting bracket.
5. Remove the bolt from the valve mounting bracket.
6. Remove the EVAP canister purge valve.

INSTALLATION PROCEDURE
1. Position the EVAP canister purge valve on the manifold.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the bolt and secure the EVAP canister purge valve.

Tighten
Tighten the [1][2]EVAP purge valve bolt to 10 N.m (88 lb in).

3. Connect the EVAP canister purge valve electrical connector and hoses.