Center Vent Temperature Sensor (G191)

Center Vent Temperature Sensor (G191)

• The Center Outlet Temperature Sensor is installed only on vehicles equipped with the "Basis" A/C system.

Removing

- Turn off the ignition.

- Remove the radio or the CD changer (depending on the vehicle equipment level).

- Reach through the installation shaft and disconnect the connector - A -.






- Turn the sensor - B - 90° and remove it from the air guide channel leading the "center" instrument panel vents.

Installing

Installation is carried out in the reverse order while observing the following.

- Check the seal - C - for damage and proper seating.

- Install the removed parts in the opposite order.

- Switch on the ignition.

- Check the Climatronic control module (J255) DTC memory and erase any displayed malfunctions if necessary. Refer to the Vehicle diagnostic tester in "Guided Fault Finding".