Glass Panel

Glass Panel

Removing


Do not move the slotted guide rail when the glass panel is removed otherwise the wind deflector can get damaged.






1 Trim

2 Front Glass Panel

• Removing

- Open the glass panel - 1 - far enough until the trim - 2 - is accessible.

- Remove the trim - 2 - in direction of - arrow A - and disengage the retaining tab - 3 - on the back side.

- Squeeze the catch - 4 - on the back - arrow B - and unclip the trim.

- Push the trim - 2 - in direction of - arrow C - and remove it.

- Remove the left and right screws on the front cover.

3 Retaining Tab

4 Locking Tab

- Remove the left and right screws - arrows - from the glass panel - 1 -.





- Lift out the glass panel.

Installation

• Always replace the screws when installing or removing the glass panel.

• Clean any remaining locking compound from the threaded holes with a thread cutter.

- Install the glass panel - 1 - from the top and install the screws - arrows - but do not tighten them.





- Adjust the front glass panel. Refer to => [ Front and Rear Glass Panel Height, Adjusting ] Adjustments.

- Tighten the screws - arrows - to the tightening specification. Refer to => [ (Item 9) Bolt ] Removal and Replacement.

- Engage the front trim - 2 - into the glass panel - 1 - and slide it in direction of - arrow A -.





- Install the catch - 4 -.

- Engage the retaining tab - 3 - on the back - arrow B -.

- After completing this procedure, perform an adaptation on the sunroof motor. Refer to => [ Sunroof Adaptation ] Testing and Inspection.