Battery Jump Start Terminal (U6)
Battery Jump Start Terminal (U6)
Observe notes on contact corrosion. Refer to=> [ Contact Corrosion ] Contact Corrosion.
Removing
- Turn off the ignition and disconnect the ground cable from the battery. Refer to=> [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.
- Remove the windshield wiper arms. Refer to=> [ Windshield Wiper Arms ] Removal and Replacement.
- Remove the seal - 1 - near the plenum chamber cover.
Danger of damaging the plenum chamber cover.
• Coat the space between the windshield and the plenum chamber cover with some soapy water.
- Carefully remove the plenum chamber cover - 2 - starting at the edge of the glass vertically from the windshield - arrows B -.
- Disengage the plenum chamber cover on the outside of the cover - 3 -. To do this, lift the cover in the center and disengage it from the guides - 4 -.
- Unlock the cover - 2 - and swivel it to the side - arrow -.
- Disconnect the positive cable - 4 -.
- Remove the nut - 3 - on the positive cable - 1 -.
- Remove the positive cable - 1 - from the threaded pin.
- Open the tabs - 1 - and - 3 - and remove the positive terminal grip - 2 - from the bracket.
- Remove the generator. Refer to 4.2L => [ Generator ] Generator or 6.3L => [ Generator ] Generator.
- Remove the right engine mount.
- Remove the bolts - arrows - and remove the right engine support - 1 -.
- Remove the nut - 1 - and disconnect the B+ wire from the solenoid switch.
- Remove the screw - 3 - and disconnect the ground wire - 2 -.
Installing
• Tightening specifications. Refer to=> [ Battery Jump Start Terminal and Positive Terminal Overview ] Battery Jump Start Terminal and Positive Terminal Overview.
Install in reverse order of removal. Note the following:
- Attach the wires to the starter. Refer to=> [ Starter Overview ] Service and Repair.
- Install the engine support and the engine mount.
- Install the generator. Refer to 4.2L => [ Generator ] Generator or 6.3L => [ Generator ] Generator.