Ignition Coil: Service and Repair

Ignition Coils

Special tools, testers and auxiliary items required

• Ignition Coil Puller (T40039)

Remove the ignition coils from cylinder bank 1

- Loosen the clamps - 1 and 2 - and remove the right air guide pipe.





- Remove the bolts - 1 - and - 2 -.





- Pull ignition coils approximately 30 mm out of spark plug shaft using (T40039).

- Release electrical connectors and remove connectors simultaneously from ignition coils.

- Remove ignition coils with (T40039) from spark plug shaft





Remove the ignition coils from cylinder bank 2

- Loosen the clamps - 1 and 2 - and remove the left air guide pipe.





- Remove oil dipstick - 1 - from guide tube.

- Remove the bolts - 2 - and - 3 -.





- Pull ignition coils approximately 30 mm out of spark plug shaft using (T40039).

- Release electrical connectors and remove connectors simultaneously from ignition coils.

- Remove ignition coils with (T40039) from spark plug shaft





Installing

- Insert all ignition coils loosely into spark plug shaft.

- Align the ignition coils to the connectors and then connect all of the connectors simultaneously onto the ignition coils.

- Press the ignition coils uniformly onto the spark plugs by hand (do not use an impact tool under any circumstances).

Further installation is performed in reverse order.

Tightening Specifications