Oil Pump and Lower Section of Oil Pan Overview
Oil Pump and Lower Section of Oil Pan Overview
Danger of catalytic converter damage.
• The oil level must not exceed the "MAX" marking.
• If large quantities of metal particles or abraded material are detected during engine repairs, it may mean the crankshaft or rod bearings are damaged. To prevent subsequent damage, the following work must be performed after the repair: Oil channels must be cleaned carefully; replace oil spray jets, engine oil cooler and oil filter.
• Oil capacities, specifications and viscosity classes refer to the Fluid Capacity Tables.
1 Oil Level Thermal Sensor (G266)
• Removing and installing, refer to => [ Oil level thermal sensor (G266) ] Service and Repair
2 Seal
• Replace
3 Bolt
• Tightening specification and sequence, refer to => [ Lower Section of Oil Pan, Tightening Specifications and Sequence ]
4 Oil Pan Lower Section
• Removing and installing, refer to => [ Oil Pan Lower Section ] Oil Pan Lower Section
5 Intake Tube
• For oil pump
6 Bolt
• Replace
• 5 Nm plus an additional 45° turn
7 Bolt
• 9 Nm
8 Bolt
• 9 Nm
9 O-ring
• Replace
10 Bolt
• Replace
• 5 Nm plus an additional 90° turn
11 Housing
• For oil check valve
• Removing and installing, refer to => [ Oil Pump ] Service and Repair
12 Gasket
• Replace
13 Gasket
• Replace
14 Bolt
• 9 Nm
15 Oil Pipes
• Removing and installing, refer to => [ Oil Pump ] Service and Repair
16 O-ring
• Replace
17 Input Shaft
• For coolant pump
18 Bolt
• 9 Nm
19 O-ring
• Replace
20 Alignment Bushing
• 2 pieces
21 Gasket
• Replace
22 Oil Pump
• Do not disassemble
• With relief valve
• Removing and installing, refer to => [ Oil Pump ] Service and Repair
23 Input Shaft
• For oil pump
24 Bolt
• Replace
• 8 Nm plus an additional 90° turn
25 O-ring
• Replace
26 Bolt
• Illustration does not correspond to version in vehicle
• Tightening specification and sequence, refer to => [ Lower Section of Oil Pan, Tightening Specifications and Sequence ]
27 Not Installed
28 Not Installed
29 Oil Drain Plug
• 25 Nm
30 Seal
• Replace
31 Nut
• 9 Nm
Lower Section of Oil Pan, Tightening Specifications and Sequence
- Tighten bolts in 3 stages as follows:
