Sill-Side Trim with Front Trim
Sill-Side Trim with Front Trim
• Removal and installation can be performed with the front seat installed.
• For reasons of clarity, the surrounding area is not shown.
Removing
- Move the front seat all the way to the rear and then into its highest position.
- Release lower retaining tabs - 2 - on the holder - 3 - and pull front trim - 1 - upward - A, B arrows -.
- Move the front seat all the way forward/up.
- Remove the front belt anchor. Refer to => [ Front Belt End Fitting ] Front Belt End Fitting.
- Pull sill side trim - 1 - upward and detach at the holder - A, B, C arrows - by releasing the lower retaining tabs - 2 - on the holder - 3 -.
- Pull off sill side trim - 2 - together with front trim - 1 - - A and B arrows - and remove.
• In order to prevent damage, make sure that all retaining tabs - 4 - on the holder - 3 - are correctly released.
- Disconnect sill side trim - 1 - from the front trim - 2 - by releasing retaining tabs - arrows -.
Vehicles without memory function:
- Disconnect the connectors:
1. Seat adjustment control head assembly (E470) / (E471)
2. Lumbar support adjustment switch (E176) / (E177)
- Free up electrical wire on the bracket - 3 -.
- Remove sill side trim.
Vehicles with memory function:
- Disconnect the connectors:
1. Front seat switch module (E663) / (E664)
2. Version with massage function: Massage button (E670) / (E671)
3. Driver seat switch module 2 (E667) / front passenger seat switch module 2 (E668)
- Free up electrical wire on the bracket - 4 -.
- Remove sill side trim.
Installing
Install in reverse order of removal. Note the following:
• Make sure the connectors are installed all the way in and are secure.
• Route the connectors and wires as illustrated.
• Make sure that the front trim and the sill panel side trim is correctly engaged on the bracket.
Installation note: For example tightening specifications, replace components => [ Sill and Tunnel Side Front Trim Assembly Overview ] Sill and Tunnel Side Front Trim Assembly Overview.