Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Counter Hold Tool (10 - 201)

Removing

• The transmission is removed.

- Insert (10 - 201) to loosen the bolts.






The outer surface of the bearing flange at the drive plate could be damaged.

• Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.

- Remove the bolts, drive plate and sensor wheel.

Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Drive Plate Overview ] Drive Plate Overview.

• Replace bolts which have been tightened to an additional torque.

- Be careful of the alignment bushings during installation.

- Reposition the (10 - 201) to tighten the bolts.