Secondary Air Injection Right Combination Valve

Secondary Air Injection Right Combination Valve

Removing

• During installation, all cable ties must be installed at the same location.

- Remove the right front muffler. Refer to => [ Front Muffler ] Front Muffler.

- Remove the right front wheel housing liner - 6 -.






- Remove the right bolts - arrows - and the right heat shield - 1 -.






- Free up the Oxygen Sensor (O2S) 2 after catalytic converter (G131) wire.

- Remove the bolt - 1 - and nuts - arrows -. Then remove the right catalytic converter from the exhaust manifold.






- Remove the throttle valve control module (J338).






- Disconnect the electrical connector - 2 - on Evaporative Emission (EVAP) canister purge regulator valve 1 (N80) and disconnect the vacuum hose - 3 - by pressing the release buttons.






- Remove the EVAP canister purge regulator valve 1 from the bracket and lay it aside with the hose connected.

• Ignore - 1 -.

- Remove the bolts - arrows - and the heat shield - 1 -.






- Remove the vacuum line - 2 - from the Secondary Air Injection (AIR) combination valve.






- Remove the bolts - 3 -, remove the right secondary air combination valve and remove the bolts - 1 - for the secondary air hose.

Installing

Install in reverse order of removal. Note the following:

Tightening specifications:

• => [ Secondary Air Injection System Overview ] Service and Repair

• => [ Secondary Air Combination Valve Heat Shield - Tightening Specification ] Service and Repair

• Replace the gasket.

- Electrical connections and routing.

- Install the subframe heat shield.

- Install throttle valve control module.

- Install the right catalytic converter. Refer to => [ Right Catalytic Converter ] Right Catalytic Converter.

- Install the front wheel housing liner.