Ribbed Belt

Ribbed Belt

Special tools, testers and auxiliary items required

• Locking Pin (T10060 A)

Removing

- Remove the supercharger ribbed belt. Refer to => [ Supercharger Ribbed Belt ] Supercharger Ribbed Belt.

- Remove the bolt - arrow - and remove the idler roller.






- Remove the bolt - 2 - on the left front coolant pipe.






• The installed position is shown in the illustration with the engine removed.

• Ignore - 1 -.

- Remove the front noise insulation - 1 -.






- Remove the bolts - 2 - on the left front coolant pipes.






• The installed position is shown in the illustration with the engine removed.

• Ignore - 1 and 3 -.

Risk of destroying due to reversed running direction on a used ribbed belt.

• For installing the ribbed belt again, mark the running direction with chalk or a felt tip pen.

- To release the tension on the ribbed belt, swivel the tensioner clockwise - arrow - and then lock the tensioner using a (T10060 A).






- Remove ribbed belt.

Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Supercharger Ribbed Belt Drive Overview ] Supercharger Ribbed Belt Drive Overview.

- Place the ribbed belt over the pulley as illustrated.






1. Generator

2. Idler roller

3. Coolant pump

4. Air Conditioning (A/C) Compressor

5. Tensioning device for ribbed belt

6. Vibration damper


• When installing the ribbed belt, make sure it is seated correctly on the pulleys.

- Install the left front coolant pipes. Refer to => [ Left Front Coolant Pipes ] Left Front Coolant Pipes.

- Start the engine and check the belt routing.

- Install the supercharger ribbed belt. Refer to => [ Supercharger Ribbed Belt ] Supercharger Ribbed Belt.