Fluid Line/Hose: Service and Repair

ATF Pipes

Special tools, testers and auxiliary items required

• Engine Bung Set (VAS 6122)

Removing






• Guidelines for clean working conditions when working on automatic transmission, refer to => [ Clean Working Conditions ] Clean Working Conditions.

- Remove the noise insulation.

• Place a cloth underneath to soak up any escaping ATF.






- Remove the union nut - arrows -.

- Place the (V.A.G 1782) under the transmission.






- Mark the ATF pipe/hose line to the ATF pipe for reinstallation.

- Remove the bolts - arrow - and disconnect ATF pipes from the transmission.

- Seal any open lines and connections with a clean plug from the (VAS 6122).

Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ ATF Pipe, ATF Cooler, and ATF Filter Overview ] Description and Operation.

There is a risk of damaging the transmission.

• Remove all the plugs on the ATF pipes and on the transmission that were installed during removal.

• The ATF cooling function will not work and the transmission will be damaged if the plugs are forgotten.

- Check the ATF level and correct if necessary. Refer to => [ ATF Level Checking, Draining and Filling Overview ] 0AW Continuously Variable Transmission.