Side Trim

Side Trim

Special tools, testers and auxiliary items required

• Engine and transmission holder (VAS 6095)






• Fixture for seat repair (VAS 6136)











1 Bolt

• Tightening specification 1.2 Nm

2 Side trim (sill side)

Removing

- Remove the seat. Refer to => [ Seat ] Seat.

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Attach the front seat to the fixture for seat repair (VAS 6136).

- Remove backrest adjustment hand wheel - 5 -.

- Remove seat height adjustment handle - 7 -. Refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle.

- Remove expanding clip - 6 -, press clamping pin through to the inside.

- Remove mounting bolt - 1 -.

- Remove side panel - 2 - at lower edge from retaining bracket on seat.

- Swing side panel upward at front edge.

- Remove side panel to side.

- Pull tab at rear of side panel out under backrest trim.

Installation

Install in reverse order of removal.

3 Side trim (tunnel side)

Removing

- Remove the seat. Refer to => [ Seat ] Seat.

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Attach the front seat to the fixture for seat repair (VAS 6136).

- Remove expanding clip - 4 -, press clamping pin through to the inside.

- Disengage retaining detent at rear side of side panel on tunnel side.

- Remove the trim.

Installation

Install in reverse order of removal.

4 Expanding clip

5 Hand wheel for backrest adjustment

• Removing and Installing, refer to => [ Backrest Adjustment Hand Wheel ] Backrest Adjustment Hand Wheel

6 Expanding clip

7 Seat height adjustment handle

• Removing and Installing, refer to => [ Seat Height Adjustment Handle ] Seat Height Adjustment Handle