Right Secondary Air Injection (AIR) Combination Valve

Right Secondary Air Injection (AIR) Combination Valve

Removing

- Removing the coolant connecting pieces. Refer to => [ Coolant Connections ] Service and Repair.

- Remove the throttle valve control module (J338).

- Remove the vacuum hose - 5 - from the AIR combination valve.






- Remove the secondary air hose - 4 - by pressing the release buttons.

- Remove the bolt - 2 - and move the bracket together with the wiring harness to the side.

- Remove bolts - 3 - and remove the right AIR combi-valve.

• Ignore - 1 -.

• To provide a better illustration, component location is shown from behind with engine removed.

Installing

Install in reverse order, paying attention to the following:

• Tightening specification, refer to => [ Secondary Air Injection System with Vacuum Control Overview ] Secondary Air Injection System With Vacuum Control Overview.

• Replace the seals and the O-rings.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Electronic Parts Catalog (ETKA).

• When installing, bring all cable ties back to same positions.

- Install throttle valve control module (J338).

- Installing the coolant connecting pieces. Refer to => [ Coolant Connections ] Service and Repair.