Hydraulic Pump Motor

Hydraulic Pump Motor

Injury risk.

• There must be no pressure inside the hydraulic system when performing the following work.

Removing

- Remove hydraulic pump. Refer to => [ Hydraulic Pump ] Hydraulic Pump.

• Before removing, place a cloth or a collector tray under the pump to catch any hydraulic fluid that may leak out.

- Open and close the fluid filler plug one time to equalize the pressure.

- Hold the pump and the motor vertically for a few minutes to drain out all the hydraulic fluid into the fluid reservoir.

- Remove the bolts - arrows -.






- Remove the motor - 1 - by lightly turning it off of the valve block - 2 -.

Installation






• Tightening specifications, refer to => [ Motor Overview and Hydraulic Pump Fluid Reservoir ] Motor Overview and Hydraulic Pump Fluid Reservoir.

Install in reverse order of removal. Note the following:

• Replace the O-ring.

- Install the new O-ring onto the valve block.

- Attach the motor to the valve block.

• Align the shaft - 1 - in accordance with the opening in the yoke - 2 - as shown in the illustration.

- Install the motor by lightly turning it onto the valve block.

- Install hydraulic pump. Refer to => [ Hydraulic Pump ] Hydraulic Pump.

- Check the fluid level and fill with fluid if necessary. Refer to => [ Hydraulic System, Filling and Bleeding ] Hydraulic System, Filling and Bleeding.