Tunnel Crossmember

Tunnel Crossmember

Special tools, testers and auxiliary items required

• Engine/Transmission Jack (V.A.G 1383 A)

• Transmission Support (T10337)

Removing

Proceed as follows:

- Remove the rear noise insulation by loosening the fasteners - 2 - and - 3 -






- Support the transmission using the (V.A.G 1383 A) with the (T10337) attached.






There is the risk of an accident.

• The (V.A.G 1383 A) may only be used during assembly and must not sit unsupervised under the vehicle.

- Remove the bolts from the tunnel crossmember - arrows -.






- Remove the nuts - arrow - and the tunnel crossmember.






Installing

• For the correct tightening specifications, refer to => [ Tunnel Crossmember, Transmission Mount and Transmission Support Overview ] Tunnel Crossmember, Transmission Mount and Transmission Support Overview.

Install in reverse order of removal.