Stabilizer Bar

Stabilizer Bar

Removing

- Remove noise insulation.

- Disconnect left and right connectors - 2 -.






- Remove the left and right nuts - 1 - and the clamp - 3 -.

- Remove the stabilizer bar.

Installing

Install in reverse order of removal. Note the following:

Tightening specifications, refer to => [ Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Shield Assembly Overview ] Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Shield Assembly Overview.

• Bonded rubber bushings can only be turned to a limited extent. Only tighten suspension screws when vehicle is in curb weight or control position.

• Wheel bearing, lifting to curb weight position on vehicles with coil springs. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] Front Suspension.

• If you replace stabilizer, note chassis version.

• Stabilizer and mounting must be free of grease.

• Install the rubber bushing opening in the direction of the subframe contact surface.

- Install the nuts - 1 - but do not tighten them.






- Install the left and right threaded connections - 2 - but do not tighten them.

- Wheel bearing, lifting to curb weight position on vehicles with coil springs. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] Front Suspension.






- Tighten connections - 1 - and - 2 -.