Rubber-Metal Mount for Rear Multicontour Seat Compressor

Rubber-Metal Mount for Rear Multicontour Seat Compressor

Special tools, testers and auxiliary items required

• Drill

• Protective eye wear

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.

• Before handling pyrotechnic components (for example, connecting the electrical connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

• Observe all measures when installing the rear seat. Refer to => [ Lower Seat Frame/Rear Seat Backrest ] Lower Seat Frame/Rear Seat Backrest.

- Removing, refer to => [ Compressor Rear Multi-contour Seat Compressor V441/V442 ] Compressor Rear Multi-contour Seat Compressor V441/V442.

- Remove module carrier with air cushions for lumbar support. Refer to => [ Module Carrier with Air Cushions for Lumbar Support ] Module Carrier with Air Cushions for Lumbar Support.








Eye injury risk.

• Wear protective eye wear!

- Drill out rivets - arrows - and remove compressor.

• For clarity, the module carrier is depicted with the compressor installed.

Installing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.

• Before handling pyrotechnic components (for example, connecting the electrical connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

• Observe all measures when installing the front seat. Refer to => [ Standard Seat ] Standard Seat.

Install in reverse order of removal. Note the following:

• The rubber-metal compress mount must not be installed under tension or twisted.

• Therefore, first bolt all rubber-metal mounts to the compressor. Refer to and then rivet them.