Headrest Cover and Cushion

Headrest Cover and Cushion

• In vehicles with the Comfort version, the cover is not separable from the cushion.

Removing






- Remove the headrest. Refer to => [ Rear Headrest ] Rear Headrest.

- Open lock by prying the upper side of the cover with the flat channel - 3 - loose from the headrest support using a screwdriver and removing it.

- Pry lower cover side with the flat channel - 1 - loose from the headrest support and remove it.

- Pull off cover and cushion - 4 - over the headrest support - 2 - and remove headrest support.

- Remove cushion from the cover.

Installing

- Insert cushion with proper fit in the cover.

- Insert headrest support in the cushion with cover.

- Close the closure by first clipping the lower flat channel of the cover into the headrest support.

- Clip the edge of the cover with the upper flat channel of the cover into the headrest support.

- After closing the closure with a needle or pointed object, line up the cover and the channels.

- Make sure the cover lies on the upholstery without any wrinkles and without seam markings.

Installation is performed in reverse order of removal, noting the following:

Installation note: For example tightening specifications, replace components => [ Headrest Cover and Padding Assembly Overview ] Headrest Cover and Padding Assembly Overview.