Left Engine Mount

Left Engine Mount

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

• Engine Support Basic Set (T40091)

• Engine Support Supplement Set (T40093)

Removing

- Remove the rear engine cover - top arrows -.





- Remove rubber seal - 1 - and remove plenum chamber cover - 2 -.





- Mount the (10 - 222 A /4) with the (T40091/3) as well as the (T40093/1) and (T40093/2) to the strut towers, as illustrated.





• Support for left and right side of vehicle is marked.

- Mount the additional parts from the (10 - 222 A), (T40091) and (T40093) as illustrated. Position the (T40093/3) on the notches on the longitudinal members.





- Engage the (10 - 222 A /10) into the left engine lifting eyelet.

- Tension the engine with the spindle.

- Remove noise insulation.





- Remove the bolts - 1 - and - 2 - for the left and right stabilizer mounts and lower the stabilizer bar slightly.





- Remove the nuts - 3 -.





- Remove the bolts - 1 - and - 2 - and remove the left engine mount bracket.

• The illustration shows the right engine mount bracket instead.

- Disconnect the connector - 1 - on the Left Electron-Hydraulic Engine Mount Solenoid Valve (N144), if equipped.





- Remove the bolts - arrows - and remove the engine supports with the engine brackets.

- Remove the nut - arrow - and remove the engine bracket from the engine support.





Installing

• Tightening specifications, refer to => [ Subframe Mount Assembly Overview ] Subframe Mount Assembly Overview.

Installation is in reverse order of removal, note the following:

• Replace bolts which have been tightened to torque.

• During installation, all cable ties must be re-installed at the same location.

- Install the subframe and stabilizer bar.