Release Button

Release Button

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)






• Removal and installation of the left button is described for a left 1/2 backrest. Removal and installation of the right button is the same.

Removing






- Remove left or right trim. Refer to => [ Left or Right Trim ] Left or Right Trim.

- Using Trim Removal Wedge (3409) , pry button - 1 - out of release - 2 -, beginning at back.

- Beginning prying with the pins facing the center of the vehicle - arrow -.

- Then pry pins facing in direction of vehicle exterior - arrow -.






• After prying rear pins out of release, leg spring - 2 - and rocker - 3 - disengage themselves from the button - 1 -.

- Then pry front pin buttons out of release in the same sequence using the Trim Removal Wedge (3409).

- Remove button from rocker.

Installation






- Slide button from behind onto rocker - 2 - and leg spring - 3 -.

1. Release


- Using trim removal wedge (3409) , engage left and right rear pins in release.

- Using trim removal wedge (3409) , engage left and right front pins in release.

- Make sure the leg spring is engaged correctly in the button.

- Install left or right trim. Refer to => [ Left or Right Trim ] Left or Right Trim.