Rear Seat Backrest Cover and Cushion

Rear Seat Backrest Cover and Cushion

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Removing






- Remove the rear seat backrest. Refer to => [ Rear Backrest ] Rear Backrest.

- Open zip fasteners - 2 - on both sides of the cover.

- Open the clamping strips - 3 - and - 4 - - arrow A -using the (3409)

- Remove the lower cover and cushion - 1 - forward - arrow B -.

- Carefully pull and remove the cushion and cover from the adhesive strips on the front side of the backrest shell.

Installing

Installation is reverse of removal, but note the following:

- Peel the protective foil off the adhesive strips and on the front side of the backrest shell when installing a new shell and cushion.

- Use new two-sided adhesive tape if re-using the old backrest shell.