Transmission Oil Cooler

Transmission Oil Cooler

Removing

- Remove the right rear wheel.

- Remove the right rear wheel housing liner.

- Remove the air duct - 1 - - arrows -.

- Remove bolt - 2 -.





- Place the Oil Collecting and Extracting Device (V.A.G 1782) the separating joint.





- Remove the union nuts - 3 - and - 4 - and the transmission oil lines from the cooler.

- Remove the bolts - arrows - and the transmission oil cooler.

• Ignore - 1 -.

Installing

• Tightening specifications. Refer to => [ Transmission Fluid Lines and Oil Cooler Assembly Overview ] Description and Operation.

Install in reverse order, paying attention to the following:

- Install the right rear wheel housing liner.

- Gear oil level, checking and topping off. Refer to => [ Oil Drain, Oil Fill and Oil Check Plug Assembly Overview ] Description and Operation.