Rear Transmission Oil Lines

Rear Transmission Oil Lines

Removing

- Remove the rear bumper cover.

R tronic:

- Body Protectors, Installing, refer to => [ Body Protectors, Installing ] Body Protectors, Installing.

- Remove the left - 1 - and right - 3 - engine compartment trim.





- Remove the engine cover - 2 -.

- Remove the air filter housing.





- Remove the bolts - 1 - and the heat shield - arrow -.





- Free up the electrical wires on the transmission fluid lines.

All Vehicles

- Place the Oil Collecting and Extracting Device (V.A.G 1782) the separating joint.

- Remove the bolt - arrow - and the transmission oil lines from the transmission oil thermostat.





• To prevent dirt from entering, seal the open lines and connections with clean plugs or caps.

- Remove nut - 3 -.





- Place the Oil Collecting and Extracting Device (V.A.G 1782) the separating joint.

- Remove the banjo bolts - 1 - and - 2 - and the transmission oil lines.

• To prevent dirt from entering, seal the open lines and connections with clean plugs or caps.

Installing

• Tightening specifications. Refer to => [ Transmission Fluid Lines and Oil Cooler Assembly Overview ] Description and Operation, => [ Heat Shield Over the R tronic Shift Actuator,
Tightening Specifications ] .

Install in reverse order, paying attention to the following:

R tronic:

- Install the air filter housing.

- Install the engine compartment trim.

All Vehicles

- Install the rear bumper cover.

- Gear oil level, checking and topping off. Refer to => [ Oil Drain, Oil Fill and Oil Check Plug Assembly Overview ] Description and Operation.