Secondary Air Injection Right Combination Valve

Secondary Air Injection Right Combination Valve

Removing

• During installation, all cable ties must be installed at the same location.

- Install protective body covers. Refer to => [ Protective Body Covers, Installing ] Procedures.

- R8 Spyder: Remove the service flap.





- Remove the air filter housing.





CAUTION!
There is a risk of destroying the transmission.

• Cover the openings - arrows - with cloths to prevent bolts or nuts from accidentally entering the transmission through them.







- Disconnect the connector - 3 - and remove the vacuum hose - 2 -.





- Remove the secondary air hose - 4 - by pressing the release buttons.

- Remove the bolts - 1 - and remove the right secondary air injection combi-valve.

Installing

• Tightening specifications, refer to => [ Secondary Air Injection System Assembly Overview ] Service and Repair.

Installation is in reverse order of removal, note the following:

• Replace the seal and O-ring.

- Install air filter housing.

- Install the service flap.