Engine, Securing to Engine and Transmission Holder

Engine, Securing to Engine and Transmission Holder

Special tools, testers and auxiliary items required

• Lifting Tackle (3033)

• Engine and Transmission Holder (VAS 6095) with Bracket for V10 5.2 Liter Engine on R8 (VAS 6095/1-10)

• Shop Crane (VAS 6100)

• Lift Arm Ext./Workshop Hoist (VAS 6101)

• Additional Hooks (10 - 222 A /2)

• Tension Strap (T10038)

Procedure

• Engine/transmission assembly removed and separated on Scissor Lift Table (VAS 6131 A) => [ Engine and Transmission, Separating ] Engine and Transmission, Separating.

- Remove the left connectors from the bracket and disconnect them:





1. For oxygen sensor 2 after catalytic converter (G131)

2. For heated oxygen sensor 2 (G108)

- Remove the right connectors from the bracket and disconnect them:





1. For oxygen sensor after three way catalytic converter (G130)

2. For heated oxygen sensor (G39)

- Free up the wires to all oxygen sensors.

- Remove nuts - 6 through 1 - and the left exhaust manifold with catalytic converter.





- Remove nuts - 6 through 1 - and the right exhaust manifold with catalytic converter.





- Remove the bolts - arrows - and then remove the left heat shield.





- Repeat the procedure on the other side of the vehicle.

- Disconnect the electrical connector - 2 - on the left electro-hydraulic engine mount solenoid valve (N144).





- Remove the bolt - 1 - and the left engine mount.

- Repeat the procedure on the other side of the vehicle.

- Remove the bolt - 1 - on the oil pump bracket and the bolts - arrows - and then remove the left engine support.





- Remove the clamp bolt - 1 -, then remove the bolts - arrows - and then remove the right engine support.





- Attach the (3033) with the (T10038) and the (10 - 222 A /2) to the engine lift eyes and to the (VAS 6100) with the (VAS 6101) as illustrated.





- Raise the engine off the (VAS 6131 A).

- Secure the engine and the (VAS 6095/1-10) to the (VAS 6095) to 42 Nm.