Oil Pump: Service and Repair

Oil Pump

Special tools, testers and auxiliary items required

• Used Oil Collecting and Extracting Device (V.A.G 1782)

• Body Repair Saw (VAS 5108)

• Engine Bung Set (VAS 6122)

Removing

- Drain engine oil.





- Remove the coolant pump. Refer to => [ Coolant Pump ] Coolant Pump.

- For the following steps, place the (V.A.G 1782) under the engine.





- Remove the bolts - 2 - and remove the oil line.

- Seal the open lines and connections with clean plugs from the (VAS 6122).

• Ignore - 1 -.

- Remove the bolt - arrow - on the oil pump bracket.





- Remove the bolts in sequence - 11 to 1 -, then lower the oil pump just a little and secure it.

- Cover the openings in the oil pump with a cloth - 1 -.





- Cut the intermediate plate - 2 - with a (VAS 5108) on the marking.

- Remove the oil pump.

Installing

• Tightening specifications, refer to => [ Oil Pump and Suction Module Assembly Overview ] Service and Repair.

Installation is in reverse order of removal, note the following:

• Replace bolts which have been tightened to an additional torque.

• Replace the gaskets and O-rings.

- Tighten the oil pump bolts => [ Oil Pump, Tightening Specification
and Sequence ] Service and Repair.





- Install the coolant pump. Refer to => [ Coolant Pump ] Coolant Pump.

- Fill the engine oil and then check the level.