Secondary Air Injection Left Combination Valve

Secondary Air Injection Left Combination Valve

Removing

- Remove the rear engine cover - top arrows -.





- Remove bolt - arrow -.





- Disconnect the electrical connector to the Engine Coolant Level Warning Switch (F66) on the bottom of the coolant reservoir and lay the reservoir aside with the coolant hoses - 1 - and - 2 - attached.

• To improve clarity, the work procedures in the following illustrations are shown with the engine removed and viewed from the rear.

- Remove electrical harness connectors - 1 - and - 2 - from bracket and disconnect.





- Free up the electrical wiring harnesses - arrow -.

- Remove the nut - 3 - and free up the Ground (GND) wire.

- Remove the double bolt and bracket.

- Remove the bolts - 3 - for the secondary air hose.





- Remove the vacuum line - 2 - from the secondary air injection (AIR) combination valve.

- Remove bolts - 1 - and remove the secondary air injection combination valve.

Installing

• Tightening specifications, refer to => [ Secondary Air Injection System Assembly Overview ] Service and Repair.

Installation is in reverse order of removal, note the following:

• Replace the gasket.