Body Emblem: Service and Repair
Lettering
=> [ Sedan ]
=> [ Avant ]
• The adhesive surfaces on the body must be free of dirt and grease.
• Clean the adhesive surfaces using cleaning solution (D 009 401 04).
• Warm the adhesive surfaces and lettering to approximately 40°C using a hot air blower.
• After assembly, press the lettering with the roller (T10314).
Special tools, testers and auxiliary items required
• Roller (T10314)
• Hot air gun (V.A.G 1416)
Sedan
Dimensional Data for Front-Wheel Drive Vehicles
• Outer edges of rear lid and lines extending from lower rear lights are used as reference edges.
• a = 31 mm
• b = 19 mm
• c = 31 mm
• d = 16 mm
• Peel off the protective film and press the lettering according to the dimensions.
Dimensional Data for All Wheel Drive (AWD) Vehicles
- Peel off the protective film and press the lettering according to the dimensions.
• a = 31 mm
• b = 19 mm
• c = 4 mm
• d = 36 mm
• e = 16 mm
- Dimension - e - must be measured for upward extension of lower badge.
S6 Dimensional Data
• a = 15 mm
• b = 31 mm
• c = 89 mm
Dimensional Data for Lettering on Fender
- Peel off the protective film and press the lettering according to the dimensions.
• a = 56 mm
• b = 58 mm
• c = 33 mm
• d = 109 mm
Vehicles without Side Turn Signals
• a = 148.5 mm
• b = 145 mm
• c = 87 mm
• d = 77 mm
• Peel off the protective film and press the lettering according to the dimensions.
S-Line Lettering
• a = 73 mm
• b = 74 mm
• c = 58 mm
- Peel off the protective film and press the lettering according to the dimensions.
Avant
Dimensional Data for Front-Wheel Drive Vehicles
• Outer edges of rear lid and lines extending from lower rear lights are used as reference edges.
- Peel off the protective film and press the lettering according to the dimensions.
• a = 55 mm
• b = 38 mm
• c = 55 mm
• d = 83 mm
Dimensional Data for All Wheel Drive (AWD) Vehicles
• a = 55 mm
• b = 38 mm
• c = 55 mm
• d = 83 mm
• e = 4 mm
• f = 60 mm
• Peel off the protective film and press the lettering according to the dimensions.